Skip to the tool
Speaker Cleaner

Speaker Fix

Run the Water sound once, then work down the tiers on this page. Stop as soon as the sound is back. Pay for repair only after the free steps fail.

165Hz

Ready

60seconds left

165 Hz pulse that pushes droplets out of the grille. 60 seconds.

Set volume to maximum, turn off silent mode, and hold the phone with the speaker facing down.

Disconnect Bluetooth headphones first, otherwise the sound plays there instead of the phone speaker.

Check the result

Play each side. A clean speaker sounds clear and equally loud on both channels.

Tier 1: free, under 5 minutes

These six steps cost nothing and take a few minutes. Do them in order, and test the sound after each one so you know which step worked.

  1. Run a cleaning sound. Set the volume to maximum, face the grille down and press Start in Water mode.
  2. Check you are raising the right volume. Media volume and ringer volume are separate, so play a video and use the volume buttons while it runs.
  3. Switch off silent mode and Do Not Disturb or Focus.
  4. Take off the case and any screen protector that sits over the speaker grille.
  5. Check the Bluetooth output. Disconnect earbuds, a car, a watch or a speaker that might be receiving the sound.
  6. Restart the phone and test again.

Tier 2: free, about 15 minutes

If the sound is still wrong, the next level is a physical clean plus a settings reset. Brush the grille with a soft dry toothbrush, or press low-tack tape or cleaning putty lightly against it and lift. Then run Dust mode again. Skip pins, toothpicks and compressed air.

Then look through the audio settings. An equalizer preset, Dolby Atmos, Adaptive sound, Mono Audio or a Balance slider pushed to one side can all make a healthy speaker sound wrong. Set them back to default, then install any pending system update. Change one setting at a time so you can see which one was the cause.

Which phones have a built-in option

Tier 3: when it costs money

If crackle stays at every volume or there is still no sound in any app, the fault is probably hardware. Check your warranty or insurance first, since a covered repair may cost little or nothing. Next try the manufacturer's service, then an independent repair shop.

Replacing the speaker module is a common repair. Back up your phone before you hand it over, and ask for a quote before work starts.

Tell the shop what you already tried, including the cleaning runs. It saves them repeating the same checks, and it helps them see whether the fault is the speaker or something else on the board.

How to know when to move up a tier

Give each cleaning sound one or two runs. If three or four runs change nothing, the problem is probably not water or dust in the grille, so there is little point repeating it.

Move to Tier 2 when Tier 1 leaves the sound unchanged. Move to Tier 3 when the speaker still crackles at every volume, or stays silent after a restart and a settings check.

Questions people ask

Which free fix should I try before anything else?

Check the silent switch, the media volume and the Bluetooth output. These take under a minute, and a connected earbud or a muted phone causes plenty of no-sound problems.

Does resetting sound settings delete my music or files?

No. Turning off an equalizer or setting Balance back to the middle changes how sound plays, not what is stored. Avoid erasing the phone or resetting all settings unless you have a backup.

Can a screen protector really block the speaker?

Yes. A protector or case edge that sits over the grille muffles the sound. Peel back the corner or take it off and test again.

Is a repair worth it on an older phone?

That depends on the phone's value and the quote. Ask for the price of a speaker module replacement first, then compare it with the cost of a newer phone. Do not decide before you have the number.

Should I try every Tier 1 step or stop when one works?

Stop as soon as the sound is back. The steps are ordered from quickest to slowest, so the first fix that works is the one you needed.

More cleaning tools